Get 100% Authentic Cisco 300-815 Dumps with Correct Answers
New Training Course 300-815 Tutorial Preparation Guide
NEW QUESTION # 12
Which IOS command creates a SIP-enabled dial peer?
- A. dial-peer voice 20 voip
- B. dial-peer voice 20 pots
- C. dial peer voice 20 sip
- D. voice dial-peer 20 sip
Answer: A
Explanation:
Section: Cisco Unified Border Element
Explanation/Reference: https://www.ciscopress.com/articles/article.asp?p=664148&seqNum=6
NEW QUESTION # 13
An engineer must route all SIP calls in the form of <user>@example.com to the SIP trunk gateway corporate local. Which two SIP route patterns can be used to accomplish this task? (Choose two.)
- A. [email protected]
- B. *.*
- C. gateway.corporate.local
- D. example.com
- E. *@example.com
Answer: B,E
NEW QUESTION # 14
The Cisco Unified Communications Manager Dialed Number Analyzer allows analysis of calls from which two devices? (Choose two.)
- A. device pools
- B. IP phones
- C. CTI route points
- D. translation patterns
- E. CTI ports
Answer: B,E
Explanation:
Section: Call Control and Dial Planning
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/dna/11_5_1/ CUCM_BK_CBA47A6E_00_cucm-dna-guide-115/CUCM_BK_CBA47A6E_00_cucm-dna-guide-
115_chapter_01.html#CUCM_TP_A5DA99E0_00
NEW QUESTION # 15
Which services are needed to successfully implement Cisco Extension Mobility in a standalone Cisco Unified Communications Manager server?
- A. Cisco CallManager, Cisco TFTP, and Cisco Extension Mobility
- B. Cisco TAPS Service, Cisco TFTP, and Cisco Extension Mobility
- C. Cisco CallManager, Cisco TFTP, and Cisco CallManager SNMP Service
- D. Cisco Extended Functions, Cisco Extension Mobility, and Cisco AXL Web Service
Answer: A
NEW QUESTION # 16
Due to a shortage of physical interfaces on a device the administrator requires that a loopback for RTP is used. Which command is required when using a loopback interface for RTP?
- A. voice-class sip bind media source-interface Loopback0
- B. voice-class sip early-offer forced.
- C. voice-class sip bind control source-interface Loopback0
- D. voice-class sip resources priority mode passthrough
Answer: A
NEW QUESTION # 17
Which section under the Real-Time Monitoring Tool allows for reviewing the call flow and signaling for a SIP call in real time?
- A. System > Tools > Trace and Log Central
- B. Voice/Video > Session Trace Log View > Open From Local Disk
- C. Analysis Manager > Inventory > Trace File Repositories
- D. Voice/Video > Session Trace Log View > Real Time Data
Answer: D
Explanation:
Section: Signaling and Media Protocols
Explanation/Reference: https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications- manager-callmanager/213583-procedure-to-analyse-call-flow-of-sip-ca.html
NEW QUESTION # 18
An administrator is configuring a cluster for ILS and wants to limit the amount of entities that Cisco Unified Communications Manager can write to the database for data that is learned through ILS. Which service parameter is used to adjust this limit?
- A. ILS Active Learned Object Upper Limit
- B. Global Data Service Parameter Limit
- C. Imported Dial Plan Replication Database Object Lower Limit
- D. ILS Max Number of Learned Objects in Database
Answer: D
NEW QUESTION # 19
If all patterns below are configured in Cisco Unified Communications Manager which would be used when dialing the pattern "123"?
- A. 12[2-5]
- B. 12!
- C. 12X (urgent priority set)
- D. 1XX (urgent Priority Set)
Answer: C
NEW QUESTION # 20
Refer to the exhibit.
An administrator is troubleshooting a situation where a call placed from a phone registered to Cisco Unified Communications Manager does not complete. The administrator wants to use the Dialed Number Analyzer on Cisco Unified CM to check which translation pattern the call is matching. However, when logging in to Cisco Unified Serviceability there is no option for Dialed Number Analyzer under the tool menu. Which two steps must be performed to resolve this issue? (Choose two.)
- A. Activate the Cisco Extended Functions service.
- B. Activate the Cisco Dialed Number Analyzer Server service.
- C. Activate the Cisco Dialed Number Analyzer service.
- D. Activate the Cisco CallManager service.
- E. Restart the subscriber
Answer: B,C
NEW QUESTION # 21
Configure Call Queuing in Cisco Unified Communications Manager. Where do you set the maximum number of callers in the queue?
- A. in Cisco Unified CM Service Parameters
- B. in Cisco Unified CM Enterprise Parameters
- C. in the telephony service configuration
- D. in the queuing configuration
Answer: D
Explanation:
Reference:
https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications- manager-callmanager/200453-Configure-CUCM-Native-Call-Queuing-Featu.html
NEW QUESTION # 22
An administrator configured Cisco Unified Mobility to block access to remote destinations for certain caller IDs. A user reports that a blocked caller was able to reach a remote destination. Which action resolves the issue?
- A. Configure an access list.
- B. Configure a mobility identity.
- C. Configure Single Number Reach.
- D. Configure Mobile Voice Access.
Answer: A
NEW QUESTION # 23
Signal number reach call phone that not answered are leaving voicemails on the cell phone rather the corporate mailbox. Which two options will resolve this issue? (Choose two.)
- A. Decrease the T301 timer Decrease the Answer Too Late timer
- B. Check the Enable Unified Mobility features checkbox
- C. Check the Enable Extend and Connect checkbox
- D. Decrease the T302 timer
Answer: A,B
NEW QUESTION # 24 
Refer to the exhibit. A user reports that when they call a specific phone number, no one answers the call, but when they call from a mobile phone, the call is answered. The engineer troubleshooting the issue is expecting the far-end gateway to cut through audio on the 183 Session Progress SIP message. Which SIP Profile configuration element is necessary for the Cisco Unified Communications Manager to send acknowledgement of provisional responses?
- A. Early Offer for G Clear Calls must be enabled.
- B. Accept Audio Codec Preferences in Received Offer must be set to On.
- C. On the SIP Profile, the configuration parameter SIP Rel1XX Options must be set to Send PRACK for all 1xx Messages.
- D. Allow Passthrough of Configured Line Device Caller Information must be enabled.
Answer: C
Explanation:
Section: Signaling and Media Protocols
Explanation
NEW QUESTION # 25
An engineer must configure a secure SIP trunk with a remote provider, with a specific requirement to use port 5065 for inbound and otubound traffic. Which two items must be configured to complete this configuration? (Choose two.)
- A. Incoming Port in Security Information of the SIP Profile configuration.
- B. Incoming Port in SIP Trunk Security Profile configuration
- C. Destination Port in SIP Trunk Security Profile configuration
- D. Destination Port in SIP Information section of the SIP Trunk configuration
- E. Incoming Port in SIP Information section of the SIP Trunk configuration.
Answer: B,D
NEW QUESTION # 26
An administrator is configuring a cluster for ILS and wants to limit the amount of entities that Cisco Unified Communications Manager can write to the database for data that is learned through ILS. Which service parameter is used to adjust this limit?
- A. ILS Active Learned Object Upper Limit
- B. Global Data Service Parameter Limit
- C. Imported Dial Plan Replication Database Object Lower Limit
- D. ILS Max Number of Learned Objects in Database
Answer: D
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_5_1SU1/systemConfig/ cucm_b_system-configuration-guide-1251su1/cucm_b_system-configuration-guide- 1251su1_restructured_chapter_0100011.html#CUCM_TK_I7C708C2_00
NEW QUESTION # 27
Which two configuration parameters are prerequisites to set Native Call Queuing on Cisco Unified Communications Manager? (Choose two.)
- A. A unicast music on hold audio source must be configured.
- B. The phone button template must have the Queue Status Softkey configured.
- C. Cisco RIS data collector service must be running on the same server as the Cisco CallManager service.
- D. Cisco IP Voice Media Streaming Service must be activated on at least one node in the cluster.
- E. The maximum number of callers allowed in queue must be 10.
Answer: C,D
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/systemConfig/ cucm_b_system-configuration-guide-1201/cucm_b_system-configuration-guide- 1201_chapter_01001101.html#CUCM_RF_C960BC9A_00
NEW QUESTION # 28
......
Cisco 300-815 exam is designed to test the knowledge and skills of professionals in implementing advanced call control and mobility services in Cisco platforms. 300-815 exam is intended for individuals who work in roles such as network administrators, network engineers, and system administrators. 300-815 exam covers a wide range of topics related to advanced call control and mobility services, including configuring and troubleshooting Cisco Unified Communications Manager, implementing Cisco Unified Communications Manager Express, and implementing mobility features.
Dumps of 300-815 Cover all the requirements of the Real Exam: https://www.testbraindump.com/300-815-exam-prep.html
Correct Practice Tests of 300-815 Dumps with Practice Exam: https://drive.google.com/open?id=1VyN9uZ1hqr6zTG3PDikbMoe_e3iL-Cri
