Tested Material Used To HPE0-J58 Test Engine Exam Questions in here [Sep-2021]
Penetration testers simulate HPE0-J58 exam PDF
NEW QUESTION 15
You completed the HPE Nimble storage replication partnership in a customer environment.
When you test the network connection from the primary partner to the secondary partner, the test fails; when you test the connection from the secondary to the primary partner, the test is successful.
What is the most likely cause of the failure?
- A. The secondary array network ports are misconfigured
- B. The secondary partner name is not configured properly
- C. The test can only be performed from the secondary array
- D. The primary partner name is not configured properly
Answer: B
Explanation:
Explanation/Reference:
NEW QUESTION 16
A customer needs to a multi-site environment where the entire inter-site transmission will be encrypted. Which products support this feature without additional licenses? (Select two.)
- A. HPE 3PAR
- B. HPE Nimble arrays with SmartReplicate (remote replication)
- C. any B-series 16Gb SAN Switch
- D. HPE StoreOnce hardware appliance
- E. HPE StoreOnce VSA
Answer: C,D
NEW QUESTION 17
A startup company is considering an HPE Nimble solution. They have a small IT budget, and they need to be future-proof for changing performance requirements. How does the Nimble architecture meet the company needs? (Select two.)
- A. non-disruptive technology refresh
- B. ability to mix-and-match All flash and hybrid nodes
- C. Support for FCoE
- D. native support for block and file services
- E. minimal downtime technology refresh
Answer: B,C
NEW QUESTION 18
A customer has recently acquired another company that is located less than 3 km from their current main location. Both locations use HPE B-Series products in their storage environment.
The customer needs to merge the 2 locations together while still using the current WAN and networking infrastructure at both locations. They need to keep their initial cost down until they are able to redesign both networking infrastructures.
Which protocol should be incorporated when providing a proposal to meet the customer needs?
- A. CWDM
- B. ISCSI
- C. FCIP
- D. DWDM
Answer: A
NEW QUESTION 19
A customer needs a data recovery solution for their HPE 3PAR array. They have the following requirements:
* RPO needs to be within three hours
* RTO needs to be within three hours
* There is no need for offsite data archive
* They will have a limited maintenance window
Which solution meets all of the customer needs?
- A. HPE StoreOnce
- B. HPE StoreAll
- C. HPE StoreEver
- D. HPE 3PAR StoreServ with RMC
Answer: D
NEW QUESTION 20
A customer is expecting rapid growth of their data storage needs on their HPE Nimble arrays. Which HPE tool should you recommend to best assist with capacity planning?
- A. One Config Advanced
- B. InfoSight
- C. NinjaCrawler
- D. NinjaStars for Nimble
Answer: A
NEW QUESTION 21
A customer wants to implement a disaster recovery plan for their current HPE 3PAR array datA. They have obtained a remote site 10km away their primary site. They have performed bandwidth testing, and have confirmed their RTT is approximately 100ms. The customer needs to provide data replication to assure the best data availability they can achieve. Which synchronization method meets their needs?
- A. Synchronous Remote Copy
- B. Peer Persistence
- C. Asynchronous Periodic Remote Copy
- D. Asynchronous Streaming
Answer: C
NEW QUESTION 22
A customer has an HPE Nimble Storage array. They plan to add a second HPE Nimble Storage array to their existing group.
What is the expected write behavior to a volume once the new array is added to the same pool as the existing array?
- A. Data will be written to the new array until it is the same percent full as the original array
- B. Data will continue to write to the first array until there is 40% free space available, and then alternate writes between the two arrays
- C. Data will immediately start to alternate writes between the two arrays
- D. Data will be stripped and automatically re-balanced across the two arrays
Answer: A
NEW QUESTION 23
A customer requests a proposal for two HPE 3PAR arrays using asynchronous periodic replication. The customer has two data centers, and the current bandwidth available for replication between the data centers is 200 Mb/s.
The customer is replicating 30TB, and the change rate is 3% in 24 hours. The customer wants to achieve an RPO of 10 minutes.
Which statement about bandwidth and replication is true for the customer requirements?
- A. The bandwidth will have to be increased, and replication must happen every 5 minutes
- B. The bandwidth is sufficient, and replication must happen every 10 minutes
- C. The bandwidth is sufficient, and replication must happen every 5 minutes
- D. The bandwidth will have to be increased, and replication must happen every 10 minutes
Answer: A
NEW QUESTION 24
Refer to the exhibit.
A customer is considering a new HPE 3PAR for the purpose of implementing deduplication and compression.
Based on the output returned from the NinjaCrawler tool, what do you know about the customer data?
- A. This data has a block size which is not optimal for HPE 3PAR
- B. This data has a video data workload profile
- C. This data is from an HP-UX system
- D. This data is a good candidate for HPE 3PAR deduplication
Answer: C
NEW QUESTION 25
A customer is interested in using HPE InfoSight Cross-stack Analytics for VMware.
Where does the customer need to make the appropriate configuration changes to makes this active?
- A. HPE 3PAR SSMC
- B. VMware vCenter
- C. HPE InfoSight Portal
- D. HPE 3PAR Service Processor
Answer: C
NEW QUESTION 26
A customer has standardized on Windows Server. They need to ensure that application and storage will move between sites as one during automated or manual failover. Which HPE 3PAR integrated solution should you recommend to the customer as a preventative measure?
- A. Cluster Extension (CLX)
- B. Serviceguard Metrocluster
- C. Site Recovery Manager
- D. Peer Persistence
Answer: A
Explanation:
Explanation/Reference:
Reference: https://tdhpe.techdata.eu/Documents/TDAS-Integrated%20Systems/Technical%20White%
20Paper_HPE%20ConvergedSystem%20700.pdf?epslanguage=en
NEW QUESTION 27
Click and drag the steps on the left into the appropriate order on the right to set up an HPE 3PAR array in InfoSight.
Answer:
Explanation:
NEW QUESTION 28
Refer to the Exhibit.
A customer with an existing HPE Nimble installation sends you the output shown. The administrator who initially set up the replication has left the company.
They ask you what the current RPO level for their replication is. How should you respond?
- A. They have an RPO of four minutes
- B. They have an RPO of two minutes
- C. They need to verify the RPO level from the host vc-ms-fileserver
- D. They need to send a screenshot of the volumes tab
Answer: A
NEW QUESTION 29
A customer has a requirement to provide Disaster Recovery for an application that is very sensitive to IO latency.
The customer has specified an RPO of less than 3 minutes for this application.
How can HPE 3PAR Remote Copy help meet the customers specified requirements?
- A. by using Synchronous Replication
- B. by using Asynchronous Streaming Replication
- C. by using Synchronous Long Distance Mode
- D. by using Periodic Asynchronous Replication with an interval of 3 mins
Answer: B
NEW QUESTION 30
A customer has started to load their HPE 3PAR 8450 with data, but are not sure what data reduction they are achieving. They ask you to run analysis and estimate the deduplication ratio of data currently on a virtual volume (VV).
Which CLI command should you use to understand data reduction ratios?
- A. checkvv
- B. showvv
- C. convertvv
- D. tunevv
Answer: A
Explanation:
Explanation/Reference:
Reference: https://manualzz.com/doc/34471724/hpe-3par-adaptive-data-reduction
NEW QUESTION 31
A customer has started to load their HPE 3PAR 8450 with data, but are not sure what data reduction they are achieving. They ask you to run analysis and estimate the deduplication ratio of data currently on a virtual volume (VV).
Which CLI command should you use to understand data reduction ratios?
- A. checkvv
- B. showvv
- C. convertvv
- D. tunevv
Answer: A
NEW QUESTION 32
A customer requires an all-flash solution that will scale out, with multiple arrays for replication. The customer also needs the solution to provide more data per terabyte of flash storage than competing solutions.
Which HPE program should you leverage in your solution to help meet the customer's requirements?
- A. HPE Store More Guarantee
- B. HPE Get Thin Guarantee
- C. HPE Nimble Timeless Storage
- D. HPE Get 6-Nines Guarantee
Answer: C
NEW QUESTION 33
A customer has a Tier 1 application that has high bandwidth and is sensitive to latency.
The customer needs a solution to support this application. The solution must support replication between two sites over dark fiber links and support an RPO of zero.
Which solution meets the customer requirements?
- A. dual HPE 3PAR 9450 arrays with data replicated using RCFC
- B. dual Nimble AF40 arrays with data replicated over FC
- C. dual Nimble HF20 arrays with data replicated over iSCSI
- D. dual HPE 3PAR 8400 arrays with data replicated using iSCSI
Answer: D
NEW QUESTION 34
You want to use FCAP authentication in an environment with FOS 7.3 running switches with no extra licenses.
What should you do to use this feature?
- A. Certificates must be obtained from a third-party vendor
- B. Certificates must be obtained from Brocade
- C. A Secure Fabric license must be added to all switches in the fabric
- D. Switches must be upgraded to FOS 7.4 or higher
Answer: D
NEW QUESTION 35
A customer needs to replicate the data on their HPE 3PAR arrays between their datacenters. Their datacenters are 250km apart. The link between the sites has an RTO of 100 ms, and they have an RPO of 3 minutes.
Which replication method should you recommend to meet the customer needs?
- A. RCFC is Synchronous mode
- B. RCIP in Asynchronous Streaming mode
- C. RCIP is Synchronous mode
- D. RCFC in Asynchronous Periodic Mode
Answer: D
NEW QUESTION 36
......
Authentic Best resources for HPE0-J58 Online Practice Exam: https://www.testbraindump.com/HPE0-J58-exam-prep.html
